Goods Lifts
Goods Lifts Bespoke Materials Handling Equipment and custom designed Lifting Equipment
Goods Lift
Goods Lift is designed to fully integrate with a Mezzanine floor.

Mezzanine Goods Lifts Telford Shropshire

Mezzanine Goods Lifts Telford Shropshire

Mezzanine Goods Lift Type Scissor Table installation Telford Shropshire. A 2000kg high lift triple scissor table with a platform size 2200mm x 1790mm with anti-slip tear plate, lift height 4400mm.

Goods lift is positioned in a 750mm deep pit (by others) and will operate at 75 seconds to maximum height. Operation 2,3 kW compact electro-motor with hydraulic pump unit and adequately sized oil tank wired to IP55 Standard.

Power unit is located outside the lift 400 Volts, 3 phases, 50 Hz at 24 Volts with IP55 insulated electrics. CYLINDERS        Normally single acting precision made units complete with pipe break valve to prevent a rapid lowering speed in the unlikely event of a hydraulic hose failure, Delfleet anti corrosion, ETCH-Primer. WEIGHT Approximately 1500KG’s.

STANDARD FINISH      Stainless Steel AISI304 platform, gates and handrails Mild steel RAL 9005; base frame and scissors Mild steel; axles, wheels and bolts.

HAND RAILS 1100mm high hand rails with 150mm high kick-boards, fitted to both long sides and one short side SAFETY GATES           1100mm high twin safety gate with 150mm high kick-boards fitted to one 1500mm side – outwards opening INTERLOCKING GATES .

The safety gates are interlocking into the control system of the lift so the platform will NOT raise or lower when the gates are open. Scissor table will be supplied with a remote power pack for ease of change over, should a fault occur. A spare power pack will also be provided.

Enclosure supplied with a four sided enclosure to both levels measuring 2.50m long x 2.09m Wide – Manufactured in 304 grade stainless steel and finished with a silicone bead blast (to give an even matt finish to the stainless steel) Ground floor: 3900mm high to the underside of the mezzanine floor.

Incorporating a 2000mm high gate to one short side. First Floor: 2100mm high. Incorporating a 2000mm high gate to one short side. Both gates will be fitted with electro-mechanical interlocks to prevent platform motion if either gate is open and to prevent the gates from being opened unless the platform is at the appropriate level.

Contact us on Tel 01553 811977  or email us at sales@manualhandlingsolutions.co.uk